User Reviews
Average Rating:
Link to This Page
There are 2 reviews for this product.
Tamper
Speaker will sound if any of the following occurs in standby mode,
and box is open.
If any zone switch is open
If any tamper switch is open.
If any port is open, micro switch is open.
Siren wont work in these states
Tamper led wont blink.but stays on.
Note from cold start alarm may take 2 min to warm up.
Siren will work when reset is completed.
For pizzo to work, connect + To connector pin 20 and to pin 18.
Whilst in bootup, if any port ,or tamper is interrupted.
Siren wont work , only speaker will make a sound .
I = about 15 Ma.
Had a problem with excessive currant drain , as zone switch was not in
fully 0 state.
Alarm will stay in tamper mode whilst a error is detected, and wont
commence a count down, until problem is corrected .
Learn mode connection info is wrong position.
If unsuccessful in learn mode , disconnect all power, and reconnect..
Switched smoke alarms will work on tamper links as power comes from alarm
supply.
Pls note, full testing can only be done by closed box and after a full
bootup.
Time out is 20 minutes.
Reviewed by: J W. Sydney Rating:  Date Reviewed: 04May2009 | | | Hi , I am on my second ls800s.
Fault is system won`t count down, tamper lights blinks.
Noting else, please help.
John
jweegen@optusnet.com.au
Reviewed by: boozer Rating:  Date Reviewed: 04May2009 | | |
|
|
|
More Lynteck Home Security and Burglar Alarms
Vouchers Feed
